The table legs are metal. The height is 710 mm. (71 cm). The supports are well suited for a desk, computer or office desk. They also look good on kitchen tables. They are made of pipes measuring 50x50 mm and 1.5 mm thick. The platform for fixing the countertop is made in the form of whiskers located at 90 degrees from each other. The size has been increased to 132x132 mm and the thickness is 4mm. This increases the stability of the furniture structure. It allows you to exclude cases of self-tapping screws being pulled out of the countertop under surface loads. The pipe is welded flush to the edge of the platform under the countertop. This ensures that the leg itself is positioned directly at the very edge of the countertop. The joints of pipes or sheet metal are always welded along the entire perimeter. This ensures special structural strength. The seams are being cleaned. The painting of the table legs is carried out with a full cycle of surface preparation and compliance with technology. This ensures good adhesion of the paint to the metal surface. It holds up well, does not chip off when hit. Resistant to mechanical stress. We use the paint only from the German manufacturer AkzoNobel. This brand provides stable quality. Beautiful texture and color. The legs are equipped with threaded supports that allow you to adjust the height and level relative to the floor. The threaded supports themselves are made of high-strength plastic and a threaded steel pin. They do not scratch the floor covering. The table support is made according to the technical documentation.